Equipment typically required (per set):
Your technology department may be able to provide you with the plastic sheet. If not, hardware stores sell polycarbonate sheets which will need to be cut to shape.
Students firstly draw a 3-4cm border on the top of the box and cut three of the four lines of the inner square, making a flap. A piece of the foil is cut and glued to the bottom face of this flap. This will act like a mirror, focussing the heat from the sun into the box. The inside of the box should be lined with more foil and then black paper should be taped on top. The black paper layer will absorb heat and the foil layer will keep that heat inside. The sheet of plastic should be taped across the flap opening, making sure that the seal is as airtight as possible.
An egg is broken and placed into a saucer. The oven can be opened using the original pizza box opening, and the saucer can be placed inside. The oven will take around half an hour to reach a high enough temperature to cook the egg but it will need to be placed in direct sunlight with the top flap directing the sunlight into the box.
The plastic layer works like a greenhouse, trapping the heat inside the oven.
Estimated technician preparation time (assuming the pizza boxes and plastic sheet have been collected) 10-15 mins.
The saucer inside the oven may be hot.
The contents of this page are for information only. Please refer to CLEAPSS, SSERC or ASE safety advice and/or publications before undertaking any preparation, practical experiment or using any equipment featured on this site or any other.