preproom.orgThe online science prep room
You are here: Home > Practicals > Erosion of Rocks

Erosion of Rocks


Small pieces of chalk or brick are shaken in a pot to simulate erosion.


This may be conducted as a demonstration or a class practical and so the amount of equipment required may vary. The chalk or brick used needs to be freshly broken up into pieces roughly 3-4cm3. About four to six pieces in each pot are usually required.

Bricks have been traditionally used in this practical and they work very well but newer bricks tend to be harder in construction and so do not break up easily. The best bricks tend to be 'London' or 'stock' bricks which are softer solid red types with a 'frog' (square indentation). Harder engineering bricks which usually have holes through them are too tough to be broken up successfully in this practical.

Small plastic pots need to be found for this practical. They need to have necks big enough to insert pieces of brick or chalk and must have a tight fitting screw cap. Old cosmetics pots work well.

Students take freshly broken up pieces of brick or chalk which have rough edges and place them in a pot. The lid is screwed on and they are shaken vigorously for a couple of minutes. The shaking simulates erosion that takes place in streams and rivers where rocks crash into each other, breaking them up into smaller pieces and creating smooth surfaces.

After the practical, the smoothed chalk pieces may be kept for other uses. The pots should be cleaned of any debris and reset with new pieces so they are ready for their next outing.


 CautionThe contents of this page are for information only. Please refer to CLEAPSS or ASE safety advice and/or publications before undertaking any preparation, practical experiment or using any equipment featured on this site or any other.